DYN-O-LOC®, ACCESSORIES AND
INSERTION MACHINE
Dyn-O-Loc®
Tie rods can be used to support duct sizes over 48”. Dyn-O-Locs insert into the ends of the hollow tie rods to provide a means of attaching the rods to the duct. Available for use in 1/2″ and 3/4″ I.D. rods they are easily inserted and and have been pull tested to withstand over 1900 lbs.
See why our Dyn-O-Locs are able to withstand over 1,900 lbs
D-Stud™
The D-Stud is a Dyn-O-Loc with the threaded stud pre-attached.
- Properly installed D-Studs are pull tested to over 1300 lbs.
- Anchors conduit in place during installation.
- Works with both insulated and non-insulated duct work.
- Allows for the installer to easily locate the pre-drilled hole.
Rod-Loc Insertion Machine
The Rod-Loc Insertion Machine offers contractors a fast and convenient way to set up rod locks and conduit. It runs off of a standard 110 volt outlet and a 70 PSI minimum air supply. Simply place either 3/4” or 1/2” conduit in the cradle and a rod loc on each side, and by the flip of a switch the air cylinder inserts a rod lock on both ends simultaneously of hollow conduit at the perfect inset spacing, eliminating the old timely hammer in method! Footswitch accessory is also available.
Rod-Loc Installation Instructions
Rod-Loc Insertion Machine in use
Dual Dyn-O-Claw™
Ductwork is often reinforced with conduit to minimize movement caused by positive or negative pressures. These conduits can twist inside the duct during transit or installation. The Dual Dyn-O-Claw is designed to join the cross section of conduits to immobilize them which further strengthens the duct. The Dual Dyn-O-Claw also eliminates any vibration or rattling sound of crossing conduit. Working in conjunction with Dyn-O-Mate Rod Locks and conduit, the Dual Dyn-O-Claw creates an effective duct strengthening system and are easier and faster than other alternatives such as ties or welding. The Dual Dyn-O-Claw works for both 1/2” and 3/4” conduit.
- Works for both 1/2″ and 3/4″ conduit
- Manufactured from 14 gauge galvanized steel
- Steel bolt secures the Dyn-O-Claw onto the conduit
